Nordland NVH9217 User Manual download pdf (Page 19)

The technical information are situated in the

rating plate on the internal left side of the ap-

pliance and in the energy label.

INSTALLATION

Read the "Safety Information" carefully

for your safety and correct operation of

the appliance before installing the

appliance.

Location

The appliance should be installed well away

from sources of heat such as radiators, boil-

ers, direct sunlight etc. Ensure that air can

circulate freely around the back of the cabi-

net. To ensure best performance, if the ap-

pliance is positioned below an overhanging

wall unit, the minimum distance between

the top of the cabinet and the wall unit

must be at least 100 mm . Ideally, however,

the appliance should not be positioned be-

low overhanging wall units. Accurate level-

ling is ensured by one or more adjustable

feet at the base of the cabinet.

If the cabinet is placed in a corner and the

side with the hinges facing the wall, the dis-

tance between the wall and the cabinet

must be at least 10 mm to allow the door to

open enough so that the shelves can be re-

moved.

Warning! It must be possible to

disconnect the appliance from the

mains power supply; the plug must

therefore be easily accessible after

installation.

10mm

10mm 100mm

Electrical connection

Before plugging in, ensure that the voltage

and frequency shown on the rating plate cor-

respond to your domestic power supply.

The appliance must be earthed. The power

supply cable plug is provided with a contact

for this purpose. If the domestic power sup-

ply socket is not earthed, connect the appli-

ance to a separate earth in compliance with

current regulations, consulting a qualified

electrician.

The manufacturer declines all responsibility

if the above safety precautions are not ob-

served.

This appliance complies with the E.E.C. Di-

rectives.

Rear spacers

Inside the appliance you find two

spacers which must be fitted as shown

in the figure.

Slacken the screws and insert the spacer

under the screw head, then retighten the

screws.

19

1 2 ... 14 15 16 17 18 19 20 21 22 23 24

Comments to this Manuals

No comments